# Schematic Electrical Rules Check (Typed Pins) > Check pin types on every net: output conflicts, undriven inputs, unpowered supply pins Run a typed-pin electrical rules check on an Ohmforge schematic: a pin-conflict matrix over input, output, bidirectional, tri-state, passive, power and open-collector pins plus drive rules for inputs, power inputs and open-collector nets. Part of usefulweb.app (https://usefulweb.app/). Part of [Ohmforge](https://ohmforge.usefulweb.app/) (ownerApp: ohmforge). Results are deterministic calculations from the inputs and the listed assumptions; the API returns exactly what the web page shows. ## Use it - Human interface: https://ohmforgepinerc.usefulweb.app/ (interactive tool at https://ohmforgepinerc.usefulweb.app/tool) - JSON API: POST https://ohmforgepinerc.usefulweb.app/api/v1/calculate with a JSON object of inputs (schema: https://ohmforgepinerc.usefulweb.app/api/v1/tool) - OpenAPI: https://ohmforgepinerc.usefulweb.app/openapi.json - MCP (Streamable HTTP): https://ohmforgepinerc.usefulweb.app/mcp - tool `ohmforge_pin_erc` ## Inputs - project (textarea): Ohmforge project JSON - Paste an exported .ohmforge.json project (at most 200 parts and 200 wires). ## Method - Every component pin gets an electrical type from Ohmforge's catalog: input, output, bidirectional, tri-state, passive, unspecified, power input, power output, open collector or open emitter. Discrete parts are passive; gate, op-amp and comparator outputs are push-pull outputs; supply pins of the real op-amp, comparator and 555 are power inputs; the 555 discharge pin is open collector; voltage sources, batteries, bench supplies and VCVS outputs are power outputs. - Pin conflicts: each unordered pair of pins on one resolved net is looked up in a symmetric matrix (error, warning or no finding), for example output–output and output–power output are errors, output–tri-state is a warning. - Drive rules: an input needs another pin on its net that can set its level (anything except inputs and power inputs); a power input needs a power output on its net; a net driven only by open-collector or open-emitter pins needs a pull-up or pull-down part. On the ground net these become warnings, because the ground symbol is a simulation reference rather than a supply. - Two-terminal voltage sources are judged per source: both terminals on one net is an error (shorted source), two sources on the same pair of nets is a warning (parallel sources); one shared terminal (series stack or common reference) is normal. - At most 100 findings are listed, errors first; the counts always include all findings. ## Limits - Pin types describe Ohmforge's built-in simulation symbols, not specific physical parts. The check does not verify voltage levels, logic families, ratings, timing or PCB rules; no findings does not prove a circuit correct or safe.